Author Index

A

  • Abbasi, Majid Energy Management in Steelmaking by Electric Arc Furnace Based on OLTC [Volume 4, Issue 1, 2020, Pages 51-67]
  • Abbasi, Majid Effect of Manganese Content on the as Cast Microstructure of Nodular ‎Cast Iron [Volume 4, Issue 4, 2021, Pages 203-213]
  • Abbasi, Seyed Mahdi Effect of Carbon Content on the Microstructure and Mechanical Properties of Hyness 25 Superalloy [Volume 4, Issue 3, 2020, Pages 137-143]
  • Abdi Bejandi, Ehsan To Produce an Advanced Zamak5 Composite with a 3D-Open Cell Copper Foam ‎by Casting Method [Volume 4, Issue 3, 2020, Pages 129-136]
  • Akhondzadeh, Adli Effect of Carbon Content on the Microstructure and Mechanical Properties of Hyness 25 Superalloy [Volume 4, Issue 3, 2020, Pages 137-143]
  • Aliabadi, Mohsen Investigating the Effect of Rapid Heating on Microstructure and Tensile Properties of Phosphorus Modified Alloy Al-Si-Cu-Mg [Volume 4, Issue 2, 2020, Pages 71-78]
  • Alishahi, Mostafa Investigation of Mechanical Properties and in vitro Corrosion Rate of Open-‎Cell Cast Magnesium Foams ‎ [Volume 4, Issue 3, 2020, Pages 155-165]
  • Amini, Ilia To Produce an Advanced Zamak5 Composite with a 3D-Open Cell Copper Foam ‎by Casting Method [Volume 4, Issue 3, 2020, Pages 129-136]
  • Arab, Najmeddin Effect of Heating Temperature and Mixing Rate in Mixing Ladle on Recycling of Aluminum Slag From Melting Furnace [Volume 4, Issue 1, 2020, Pages 31-37]
  • Arabi, Hossein Effect of Solution Cooling Rate on Microstructure and Hardness of X-750 Superalloy ‎ [Volume 4, Issue 3, 2020, Pages 145-153]
  • Asadi, Jaber Investigation of Mechanical Properties and in vitro Corrosion Rate of Open-‎Cell Cast Magnesium Foams ‎ [Volume 4, Issue 3, 2020, Pages 155-165]
  • Ashkevary, Sahar Investigation on Effects of Melt Temperature on Solidification Behavior of ‎ in-situ Al-Mg2Si Composite using Cooling Curve Thermal Analysis‎ [Volume 4, Issue 1, 2020, Pages 1-9]

B

  • Boutorabi, Seyed Mohammad Ali Effect of Solution Cooling Rate on Microstructure and Hardness of X-750 Superalloy ‎ [Volume 4, Issue 3, 2020, Pages 145-153]

D

  • Davari, Mohadeseh Thermodynamic Modeling of the Melting Behavior of Metallic Nanoparticles ‎Embedded in a Matrix [Volume 4, Issue 4, 2021, Pages 227-236]

E

  • Etminan, Mostafa Evolution of Aging Treatment Effect on the Microstructure and Hardness of a ‎Co-Al-W-Ti-Ta Based Superalloy ‎ [Volume 4, Issue 2, 2020, Pages 89-98]
  • Etminan, Mostafa Effect of Aging on the High Temperature Mechanical Properties of a Novel Co-‎‎7Al-7W-4Ti-2Ta Superalloy [Volume 4, Issue 4, 2021, Pages 193-201]

F

  • Fallah, Parastoo The Effect of Withdrawal Rate on the Microstructure of Ni-based Superalloy GTD-111 through the Directional Solidification [Volume 4, Issue 4, 2021, Pages 237-246]
  • Fazeli, Hamid Prediction of Shrinkage Porosity and its Remedy by Numerical Simulation in a Conical Carbon Steel Casting [Volume 4, Issue 1, 2020, Pages 39-50]

G

  • Ghazi mir Saeed, seyed Mahdi Evolution of Aging Treatment Effect on the Microstructure and Hardness of a ‎Co-Al-W-Ti-Ta Based Superalloy ‎ [Volume 4, Issue 2, 2020, Pages 89-98]
  • Ghazi Mir Saeed, Seyed Mahdi Effect of Aging on the High Temperature Mechanical Properties of a Novel Co-‎‎7Al-7W-4Ti-2Ta Superalloy [Volume 4, Issue 4, 2021, Pages 193-201]

H

  • Hanachi, Mehrdad The Effects of Cooling Rate after Solutionizing on the Microstructural ‎Evaluation of Cast IN718 Superalloy during Long-Term Thermal Exposure [Volume 4, Issue 3, 2020, Pages 175-184]
  • Heydari, Asghar Prediction of Shrinkage Porosity and its Remedy by Numerical Simulation in a Conical Carbon Steel Casting [Volume 4, Issue 1, 2020, Pages 39-50]
  • Hoseini, Seyed Alireza Investigation of Mechanical Properties and in vitro Corrosion Rate of Open-‎Cell Cast Magnesium Foams ‎ [Volume 4, Issue 3, 2020, Pages 155-165]

J

  • Jabbareh, Mohammad Amin Thermodynamic Modeling of the Melting Behavior of Metallic Nanoparticles ‎Embedded in a Matrix [Volume 4, Issue 4, 2021, Pages 227-236]
  • Jafarzadegan, Mostafa Effect of Si on Castability of Al-Cu-Si Alloys [Volume 4, Issue 4, 2021, Pages 215-226]
  • Javahery, Mojtaba Effect of Manganese Content on the as Cast Microstructure of Nodular ‎Cast Iron [Volume 4, Issue 4, 2021, Pages 203-213]

K

  • Karbasian, Gholamreza Prediction of Shrinkage Porosity and its Remedy by Numerical Simulation in a Conical Carbon Steel Casting [Volume 4, Issue 1, 2020, Pages 39-50]
  • Kebriyaei, Amir The Effect of Withdrawal Rate on the Microstructure of Ni-based Superalloy GTD-111 through the Directional Solidification [Volume 4, Issue 4, 2021, Pages 237-246]
  • Khiabani, Arash Effect of Remelting and Standard Heat Treatment on Microstructure ‎and ‎Mechanical Properties of IN738LC Superalloy [Volume 4, Issue 2, 2020, Pages 99-109]
  • Khiabani, Arash The Effects of Cooling Rate after Solutionizing on the Microstructural ‎Evaluation of Cast IN718 Superalloy during Long-Term Thermal Exposure [Volume 4, Issue 3, 2020, Pages 175-184]
  • Kiani-Rashid, Ali-Reza Design of Refractory High-Entropy Alloys to Reduce Weight and Cost ‎ [Volume 4, Issue 3, 2020, Pages 167-173]
  • Kianvash, Abbas Effects of Chemical Composition and Heat Treatment Conditions on the ‎Magnetic Properties and Microstructure of Cast Fe–Cr–Co Magnets‎ [Volume 4, Issue 1, 2020, Pages 11-20]
  • Korojy, Bahman Investigation of Mechanical Properties and in vitro Corrosion Rate of Open-‎Cell Cast Magnesium Foams ‎ [Volume 4, Issue 3, 2020, Pages 155-165]

L

  • Limooei, Mohammad Bagher Formation of Zinc-Aluminum Flake Coating on Cast Iron Disc and Consideration of Corrosion Behavior [Volume 4, Issue 1, 2020, Pages 21-29]

M

  • Mehmannavaz, Hossein Prediction of Shrinkage Porosity and its Remedy by Numerical Simulation in a Conical Carbon Steel Casting [Volume 4, Issue 1, 2020, Pages 39-50]
  • Mirbagheri, Seyed Mohammad Hossein To Produce an Advanced Zamak5 Composite with a 3D-Open Cell Copper Foam ‎by Casting Method [Volume 4, Issue 3, 2020, Pages 129-136]
  • Mohseni Zonoozi, Elnaz Effects of Chemical Composition and Heat Treatment Conditions on the ‎Magnetic Properties and Microstructure of Cast Fe–Cr–Co Magnets‎ [Volume 4, Issue 1, 2020, Pages 11-20]
  • Morakabati, Maryam Evolution of Aging Treatment Effect on the Microstructure and Hardness of a ‎Co-Al-W-Ti-Ta Based Superalloy ‎ [Volume 4, Issue 2, 2020, Pages 89-98]
  • Morakabati, Maryam Effect of Aging on the High Temperature Mechanical Properties of a Novel Co-‎‎7Al-7W-4Ti-2Ta Superalloy [Volume 4, Issue 4, 2021, Pages 193-201]
  • Mostafavi, Mohammad Effect of Si on Castability of Al-Cu-Si Alloys [Volume 4, Issue 4, 2021, Pages 215-226]

N

  • Naser-Zoshki, Hamed Design of Refractory High-Entropy Alloys to Reduce Weight and Cost ‎ [Volume 4, Issue 3, 2020, Pages 167-173]
  • Nasri, Mehdi Effect of Remelting and Standard Heat Treatment on Microstructure ‎and ‎Mechanical Properties of IN738LC Superalloy [Volume 4, Issue 2, 2020, Pages 99-109]

O

  • Omranian Mohammadi, Peiman Formation of Zinc-Aluminum Flake Coating on Cast Iron Disc and Consideration of Corrosion Behavior [Volume 4, Issue 1, 2020, Pages 21-29]

R

  • Rahimi, Abolfazl Developing Ag-9Pd (Silvadium) Casting Alloys with High-Luminosity Lifespan ‎for Traditional Jewelry‎ [Volume 4, Issue 2, 2020, Pages 111-118]
  • Ramezani, Nabiollah Energy Management in Steelmaking by Electric Arc Furnace Based on OLTC [Volume 4, Issue 1, 2020, Pages 51-67]
  • Razavi, Seyed Hosein Effect of Remelting and Standard Heat Treatment on Microstructure ‎and ‎Mechanical Properties of IN738LC Superalloy [Volume 4, Issue 2, 2020, Pages 99-109]
  • Rezaeian, S. Mohammad Energy Management in Steelmaking by Electric Arc Furnace Based on OLTC [Volume 4, Issue 1, 2020, Pages 51-67]

S

  • Saffari, Elaheh An Investigation on the Effect of Chill Modification on Microstructure and ‎Quality Index of Al-15Mg2Si Composite [Volume 4, Issue 2, 2020, Pages 79-87]
  • Saghafian Larijani, Hassan Investigating the Effect of Rapid Heating on Microstructure and Tensile Properties of Phosphorus Modified Alloy Al-Si-Cu-Mg [Volume 4, Issue 2, 2020, Pages 71-78]
  • Seifollahi, Masumeh Effect of Carbon Content on the Microstructure and Mechanical Properties of Hyness 25 Superalloy [Volume 4, Issue 3, 2020, Pages 137-143]
  • Seyedraoufi, Zahra Sadat Effect of Remelting and Standard Heat Treatment on Microstructure ‎and ‎Mechanical Properties of IN738LC Superalloy [Volume 4, Issue 2, 2020, Pages 99-109]
  • Seyedraoufi, Zahra Sadat The Effects of Cooling Rate after Solutionizing on the Microstructural ‎Evaluation of Cast IN718 Superalloy during Long-Term Thermal Exposure [Volume 4, Issue 3, 2020, Pages 175-184]
  • Shabestari, Saeed Investigation on Effects of Melt Temperature on Solidification Behavior of ‎ in-situ Al-Mg2Si Composite using Cooling Curve Thermal Analysis‎ [Volume 4, Issue 1, 2020, Pages 1-9]
  • Shajari, Yazdan Effect of Remelting and Standard Heat Treatment on Microstructure ‎and ‎Mechanical Properties of IN738LC Superalloy [Volume 4, Issue 2, 2020, Pages 99-109]
  • Shamsian Jeze, Mahya Effect of Solution Cooling Rate on Microstructure and Hardness of X-750 Superalloy ‎ [Volume 4, Issue 3, 2020, Pages 145-153]

T

  • Tabatabaei Rezaei, Nima Investigating the Effect of Rapid Heating on Microstructure and Tensile Properties of Phosphorus Modified Alloy Al-Si-Cu-Mg [Volume 4, Issue 2, 2020, Pages 71-78]
  • Taghiabadi, Reza An Investigation on the Effect of Chill Modification on Microstructure and ‎Quality Index of Al-15Mg2Si Composite [Volume 4, Issue 2, 2020, Pages 79-87]
  • Taghiabadi, Reza Effect of Si on Castability of Al-Cu-Si Alloys [Volume 4, Issue 4, 2021, Pages 215-226]
  • Tavakoli, Rouhollah Optimum design of sprue well using computer simulation and experimental study [Volume 4, Issue 2, 2020, Pages 119-126]

V

  • Vahdati-Khaki, Jalil Design of Refractory High-Entropy Alloys to Reduce Weight and Cost ‎ [Volume 4, Issue 3, 2020, Pages 167-173]
  • Varahram, Nasser The Effect of Withdrawal Rate on the Microstructure of Ni-based Superalloy GTD-111 through the Directional Solidification [Volume 4, Issue 4, 2021, Pages 237-246]

Y

  • Yari Dehkaboudi, Ali Optimum design of sprue well using computer simulation and experimental study [Volume 4, Issue 2, 2020, Pages 119-126]
  • Yousefpuor, Daniel Effect of Manganese Content on the as Cast Microstructure of Nodular ‎Cast Iron [Volume 4, Issue 4, 2021, Pages 203-213]

Z

  • Zamani, Mohammad Reza Effect of Carbon Content on the Microstructure and Mechanical Properties of Hyness 25 Superalloy [Volume 4, Issue 3, 2020, Pages 137-143]